Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)- Choose A, B or C
□
This microwave oven is designed for adaptation to the following
three types of ventilation:
A.
Recirculating (Non-Vented Ductless)
B.
Outside Back Exhaust (Horizontal Duct)
C.
Outside Top Exhaust (Vertical Duct)
NOTE: This microwave is shipped assembled for
recirculating. Select the type of ventilation required for your
installation and proceed to that section.
A. RECIRCULATING (NON-VENTED DUCTLESS)
See page 11
Models are shippedfor recirculating exhaust. Some models have a
disposable charcoal filter installed to help remove smoke and odors.
A. Recirculating (Non-Vented Ductless)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Blower Plate
A4. Mount the Microwave Oven
A5. Install or change Charcoal Filter
NOTE: Make sure the screws for the blower motor and
blower plate are securely tightened when they are reinstalled.
This will help to prevent excessive vibration.
NOTE: Make sure the motor wiring has been properly routed
and secured, and that the wires are not pinched.
B. OUTSIDE BACK EXHAUST (HORIZONTAL DUCT)
See page 17
C. OUTSIDE TOP EXHAUST (VERTICAL DUCT)
See page 21
NOTE: Read the pages 15-16 only if you plan to vent
your exhaust to the outside. If you plan to recirculate the
air back into the room, proceed to page 11.
3/8" TO EDGE
along the dotted line.
Trim the rear wall template
12"
NOTE: IT IS VERY IMPORTANT
TO
THE DIRECTIONS
READ AND FOLLOW
IN THE INSTALLATION
INSTRUCTIONS
WITH THIS
BEFORE PROCEEDING
REAR WALL TEMPLATE.
4"
This Rear Wall Template
serves to position the bottom
mounting plate and to locate
the horizontal exhaust
outlet.
that the template is positioned
1. Use a level to check
2. Locate and mark at least
accurately.
one stud on the left or
right side of the centerline.
It is important to use at
least one wood
screw mounted firmly in
a stud to support the weight
of the microwave. Mark
two additional, evenly spaced
locations for the supplied
toggle bolts.
locations. Where there
is
3. Drill holes in the marked
for wood screws. For holes
a stud, drill a 3/16" hole
that do not line up with
a stud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE
MOUNTING PLATE
AT THIS TIME.
4. Remove the template
from the rear wall.
book for your
5. Revie
h t
w
e Installation Instruction
installation situation.
Darle vuelta a la hoja
para consultar la
versión en Español.
to align with holes in the
Locate and mark holes
mounting plate.
IMPORTANT:
STUD ON EITHER SIDE
OF
LOCATE AT LEAST ONE
THE CENTERLINE.
MARK THE LOCATION
FOR 2 ADDITIONAL,
EVENLY
IN THE MOUNTING
PLATE
SPACED TOGGLE BOLTS
AREA.
Locate and mark holes
to align with holes in the
m
o
u
t n
n i
g
l p
t a
. e
IMPORTANT:
STUD ON EITHER SIDE
OF
LOCATE AT LEAST ONE
THE CENTERLINE.
FOR 2 ADDITIONAL,
EVENLY
MARK THE LOCATION
IN THE MOUNTING PLATE
Trim the rear wall template
along the dotted line.
SPACED TOGGLE BOLTS
AREA.
11
Adapt or must be
moved to the back for
outside back exhaust
Adaptor in place for
outside top exhaust
Publicité
