Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)
ALIGNING THE WALL PLATE
□
Draw a vertical line on the wall at the center of the 30 in. wide
space.
□
Draw a horizontal line on the wall at the bottom of the "Rear Wall
Template".
Find a wall stud in area "E" of the mounting plate
□
Refer to section Finding the Wall Studs.
For attaching the mounting plate into the stud, drill a 3/16 in. hole
□
into wood stud. Drill a 5/8 in. hole for toggle bolt in 1 other location
(Hole A or Hole B).
NOTE: Do not mount the plate at this time.
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves to position the bottom
mounting plate and to locate the horizontal exhaust
outlet.
1. Use a level to check that the template is positioned
accurately.
2. Locate and mark at least one stud on the left or
right side of the centerline.
It is important to use at least one wood
screw mounted firmly in a stud to support the weight
of the microwave. Mark two additional, evenly spaced
locations for the supplied toggle bolts.
3. Drill holes in the marked locations. Where there is
a stud, drill a 3/16" hole for wood screws. For holes
that do not line up with a stud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE MOUNTING PLATE
AT THIS TIME.
4. Remove the template from the rear wall.
5. Review the Installation Instruction book for your
installation situation.
Darle vuelta a la hoja para consultar la
versión en Español.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
Hole
Horizontal Line
Area E
3/8" TO EDGE
12"
Trim the rear wall template along the dotted line.
4"
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
Centerline
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
Draw a Vertical Line
notches
on Wall from Center
of Top Cabinet
Hole
C L
Draw a horizontal line on wall at the
bottom of "Rear Wall Template".
NOTE: Holes A and B are inside area E. If neither of Holes A
and B are in a stud, find a stud somewhere in area E and
draw a circle to line up with the stud. It is important to have at
least one wood screw mounted firmly in a stud to support the
weight of the microwave. Set the mounting plate aside.
10
Horizontal Line
Publicité
