Replace The Sensor Strip & The Battery; Battery Replacement - TENA SmartCare Change Indicator Mode D'emploi

EN REPLACE THE SENSOR STRIP & THE BATTERY
Sensor strip replacement
The sensor strip is designed to withstand approximately 12 weeks of continuous use.
Sometimes, however, the hooks on the back of the sensor strip can become covered with
fibers or lint. This prevents the hooks from attaching to the incontinence product. If the
fibers or lint cannot be removed, the sensor strip should be replaced. The sensor strip
should also be replaced if it becomes soiled with feces and cannot be cleaned sufficiently.
For cleaning advice, see p. 23 of this guide.
Press
1

Battery replacement

If the LED light starts to blink, either the battery needs to be replaced or the transmitter is
not properly attached to the sensor strip. The CR2032 battery will last for up to 12 weeks.
Press to
1
release
CHECK
If you have difficulty removing the battery, first press the locking tab,
then tap the transmitter in your hand until the battery falls out.
The transmitter is designed to withstand attachment and removal from
a sensor strip four times per year over two years. With more frequent
attachments/ removals, the system may not work as intended.
A pen or similar
can also be used
Remove the
2
battery
22
TENA SmartCare Change Indicator
Remove the
2
transmitter
TM/MC