Laserworld Ecoline Serie Mode D'emploi page 5

8. Operation
a. Connect the power cable to the device and then to the mains
b. Insert the key into the key switch and turn it „ON"
c. Connect the Interlock Connector with the Interlock interface
d. Press „ON" to switch the device on
8.1. Automatic, Stand-alone operation
Set the device to auto mode:
8.2. Music mode, Sound-to-light operation
Your device runs in music mode:
Control the music-sensitivity with the trim pot at the back panel. The LED is flas-
hing when the device is triggered.
8.3. Master-Slave-mode
To use the daisy chain mode, connect two (or more) laser projectors of the same
series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 (DMX in) ...etc.
If you use the master projector in music mode or in auto mode, set all DIP switches
of every slave projector to off.
If you use the master projector in DMX mode, set DIP switch 1 of every slave projec-
tor to on and every other DIP switch (2-10) to off.
8.4. DMX-512 mode
Switch 10 must be set to „off", the other switches are used for setting the DMX
address:
Connect a DMX controller to operate the laser.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch represents a
number. To define a number use the preceding number and multiply it by 2:
1 2 3 4 5
Switch
Number 1 2 4 8 16
The laser uses 9 DMX channels, so make sure that the next device uses an address
that doesn't overlap with this range (8 channels after the start address must not be
used for other DMX devices).
Channel Value
1 0 - 49
(Mode)
50 - 99
100 - 149
150 - 199
200 - 255
2 0 - 255
3 0 - 255
4 0 - 39
(Color)
40 - 79
80 - 119
120 - 159
160 - 199
200 - 239
240 - 255
5 0 - 255
6 0 - 255
7 0 - 255
8 0 - 255
9 0 - 255
Please note that a pattern can not necessarily be combined with each effect.
8.5. Turn laser off
To turn off the device switch it off („OFF"), switch the key to „OFF" and disconnect
the power cable from the mains.
6 7 8 9 10
32 64 128 256 Mode Switch
Function
Laser off
Sound mode
Automatic mode
Static patterns of DMX mode
Dynamic patterns of DMX mode
Pattern selection
Strobe effect
White color
Yellow color
Purple color
Cyan color
Red color
Green color
Blue color
x axis positioning
y axis positioning
Scan speed
Dynamic patterns speed
Zoom