Laserworld Ecoline Serie Mode D'emploi page 4

-
Always ensure sufficient ventila-
tion.
-
Do not face spotlights (especially
moving heads) to the device.
-
Check temperature after approx.
30 minutes with each new ins-
tallation. If necessary install the
projector at a place with different
temperature.
-
Switch off device when it is not
needed. Diodes are switched on
and can wear out even if there is
no visible laser output.
-
Keep the device dry. Protect it
from moisture, rain and damp.
• The devices of Ecoline, Evolution,
Club and Proline Series are not
meant for professional applica-
tions. After approx. one hour of
operation, the device should cool
down for about 15 minutes.
6. Warnings and other notices on the device
Laser radiation!
Avoid exposure
to beam
Laser class 3B
Caution of ra-
diation if cover
is removed
Use in enclosed spaces only!
• Please ensure the fans and
heatsinks are clear from dust and
debris otherwise the risk of over-
heating may occur. If the unit and
airways appear to be blocked then
please contact a qualified service
engineer to maintain and service
the product.
• Always place the laser behind fog
machines and hazers
• Avoid direct exposure of the laser
to moisture
• Clean the exit window with glass
cleaner from time to time
• Removal of the warranty label
as well as damages to the device
caused by improper handling,
neglect of the safety instruc-
tions and service notes will void
the warranty.
Model type
Production year
Wavelength
Output power
Power supply
& consumption
7. Device connections
Laser apertures
mains connection DMX out
ON/OFF switch DMX in
LED:
Laser emission
DMX address,
operation
mode
trim pot for
music-
sensitivity
key switch microphone
Interlock LED:
Sound sensitivity