Use - Batavia MAXX Série Mode D'emploi

Mounting
8.2
• Apply a few drops of oil to the shaft of
the accessory.
• Slide the locking sleeve (3) to the rear.
• Insert the accessory into the chuck (2).
• Release the locking sleeve (3).
Removing
8.3
• Slide the locking sleeve (3) to the rear.
• Remove the accessory from the chuck
(2).
• Release the locking sleeve (3).
Mounting and removing the auxiliary
8.4
grip
(fig. A & C)
Mounting
8.5
• Loosen the auxiliary grip (11) by turning
it counterclockwise.
• Mount the auxiliary grip (11) by sliding it
over the chuck (2).
• Turn the auxiliary grip (11) to the
required position.
• Tighten the auxiliary grip (11) by turning
it clockwise.
Removing
8.6
• Loosen the auxiliary grip (11) by turning
it counterclockwise.
• Remove the auxiliary grip (11).
• Tighten the auxiliary grip (11) by turning
it clockwise.
Mounting and removing the depth
8.7
stop
(fig. C)
Mounting
8.8
• Loosen the clamping knob (4).
• Insert the depth stop (1) through the
hole in the auxiliary grip (11).
• Set the depth stop (1) to the required
position.
• Tighten the clamping knob (4).
Removing
8.9
• Loosen the clamping knob (4).
• Remove the depth stop (1).
• Tighten the clamping knob (4).
Mounting and removing the dust
8.10
collector
(fig. A & D)
7062733-SDS_Plus_Hammerdrill-Ma-1801-08.indb 7
The dust collector prevents dust from enter-
ing the machine when drilling into ceilings.
Immediately replace a damaged
dust collector.
Mounting
8.11
• If necessary, remove the accessory
from the chuck (2).
• Slide the dust collector (13) over the
shaft of the accessory.
• Insert the accessory with the dust col-
lector (13) into the chuck (2).
Removing
8.12
• Remove the accessory with the dust
collector (13) from the chuck (2).
• Remove the dust collector (13) from the
accessory.

9. Use

Switching on and off
9.1
(fig. A)
• To switch on the machine, press the on/
off switch (7).
• To switch off the machine, release the
on/off switch (7).
Setting the operating mode
9.2
(fig. A & E)
The drill selection switch (5) and the ham-
mer selection lever (8) must be set accord-
ing to the required operating mode. Refer to
the table below to set the required operating
mode.
English
7
16-03-18 12:42