Proline SAC SP140E Notice D'utilisation page 20

ENGLISH
DISCONNECTING THE INDOOR AND OUTDOOR UNIT
12
If the indoor unit needs to be disconnected from the outdoor unit, to place it in a more
suitable position, follow these steps:
Disconnecting
Figure A:
• open the tube connecting box (12) situated at the back of the indoor unit.
Figure B:
• disconnect the drain tube (I).
• disconnect the electrical cable (II).
• disconnect the refrigerant tubes (III) using the spanners provided (15).
The terminals are fitted with automatic self-sealing valves to prevent the gas from leaking.
Loosen the nuts quickly, so the seal is made promptly.
During the operation take extreme care not to break the refrigerant tube.
• cap the terminals with the caps (16) provided, to protect them from dust.
Mount the outdoor unit on the bracket as described on page 14.
Connecting
Figure C:
• pass the connecting tube through the hole (at least dia. 50 mm) if present.
• remove the protection caps (if used previously).
• reconnect the refrigerant tubes (tighten the nuts quickly to make a good seal), the drain
tube and the electrical cable.
Figure D:
• close the connection box on the indoor unit.
20
III
I
II
III
A
I drain tube
II electrical cable
III refrigerant tube
Downloaded from www.vandenborre.be
(FOR QUALIFIED PERSONNEL)
III
15
B
I
II
III
C
D