Publicité
Les langues disponibles
Les langues disponibles
Mounting – Installing
The cut sizes are:
5RG64361
5RG74351
5RH84353
•
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
•
This appliance complies with type Y with regard to protection against fire hazards. Only
appliances of this type may be installed on one side of adjacent tall cupboards or walls.
However, no furniture or appliances may be higher than the hob from the other side.
•
The furniture item or base in which the hob is to be installed, as well as the furniture edges, the
laminate coatings and the adhesive used to fix them, must be able to withstand temperatures up
to 100 °C.
•
The wall bars of the edge must be heat-resistant.
•
The hob may not be installed on top of a non-ventilated oven or dishwasher.
•
There must be a clearance of 20 mm beneath the bottom of the hob casing to ensure good air
circulation.
•
If there is a drawer under the hob, no flammable (e.g. sprays) or heat-resistant objects should
be stored there.
•
Materials frequently used to make worktops expand on contact with water. To protect the cut-
out edge, a layer of lacquer or a special sealant should be applied. Special care must be taken
when applying the adhesive joint supplied with the hob to prevent leakage into the furniture
below. In combination with smooth worktops, this seal guarantees proper sealing.
•
The safety distance between the hob and the extractor hood mounted above it must comply with
the hood manufacturer's instructions. In the absence of such instructions, a minimum distance
of 650 mm must be maintained.
•
The connection cable may not be subjected to mechanical stress after installation.
A
590 mm
520 mm
780 mm
520 mm
784 mm
524 mm
B
E
560 mm
750 mm
750 mm
15
F
490 mm
57 mm
490 mm
57 mm
490 mm
57 mm
H
Publicité
