Infraworld Saunacontrol C4 Notice De Montage Et D'utilisation page 23

4.1. Power unit:
The power unit is placed on the roof of the sauna cabin and fixed with two screws.
4.2. Mounting the operating unit to hang onto outer wall:
(see enclosed drilling template):
I. Drill a hole with a diameter of 20 mm at the position of the cable duct, at a height
of approx. 1500 - 1700 mm (Fig. 1).
II. From the drilled hole measure 65 mm to the top, then 40 mm to the left. This is the position of the left
mounting screw (Fig. 2).
III. Fix the right mounting screw at a horizontal distance of 110 mm (Fig. 2).
IV. Next, use a pulling aid to lead the black connecting cable through the drilled hole onto the roof and
connect it to the power unit (Fig. 4).
V. Seal the hole with an insulating wool or adhesive tape.
VI. Finally, hook the operating unit onto the fixed screws (Fig. 3).
Fig. 1
Fig. 4
4.3. Assembly of the infrared radiator controls
Drill a hole with a diameter of 60 mm. The controls for dimming the infrared radiator can be installed
directly next to the radiator in the sauna according to demand. In total, 2 controls can be connected to
the power unit (see Fig. 5).
4. ASSEMBLY
Fig. 2
Fig. 5
Fig. 3
EN
23