TOOLCRAFT LDM 30 P Mode D'emploi page 41

2. Now measure both necessary distances. For the correct order,
see the following illustration or follow the flashing segments of the
indicator for indirect measurement.
3. Activate the target laser (B) by pushing the button ON (C).
4. Push the button ON to measure the first side length. The
measurement is shown in the upper line.
5. Activate the target laser by pushing the button ON.
6. Push the button ON to measure the second side length. The second
side length is measured continuously. The minimum measurement
is shown in the middle line, the real-time measurement is shown
in the bottom line.
7. Push the button ON to register the minimum measurement of the
second side length. The height is calculated automatically and is
shown in the bottom line.
41