TOOLCRAFT LDM 30 P Mode D'emploi page 39

4. Push the button ON to end continuous measurement. The
measurement values remain visible.
13. Area measurement
1. Push the button FUNC (G). A parallelogram appears at the top of the
display to indicate area measurement.
2. Activate the target laser (B) by pushing the button ON (C).
3. Push the button ON to measure the first side length of the area. The
measurement is shown in the upper line.
4. Activate the target laser by pushing the button ON.
5. Push the button ON to measure the second side length of the area.
The measurement is shown in the middle line.
6. The device multiplies both readings automatically. The total area is
shown in the bottom line.
39