Roborock Q5 Pro+ Manuel D'utilisation page 10

Note: If the robot fails to find the dock, it will
automatically return to its starting location. Place the
robot on the dock manually to recharge.
Error
If an error occurs, the power indicator will
flash red and a voice alert will sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
System Reset
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system. Press the Reset button,
and the robot will reset automatically.
Note: After resetting the system, scheduled cleaning,
WiFi, etc. will be restored to factory settings.
Restore Factory Settings
If the robot does not function properly after a
system reset, switch it on. Press and hold the
button and at the same time, press the
Reset button until you hear the "Restoring
factory settings" voice prompt. The robot will
then be restored to factory settings.
Routine Maintenance
C
Main Brushes
C1
* Clean every 2 weeks and replace every 6-12 months.
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush Bearing
C1-4—Main Brush
C1-5—Main Brush Caps
C1-6—Turn over the robot and press the
latches to remove the main brush
cover.
C1-7— Remove the main brush and pull out
the main brush bearing.
C1-8— Pull out the main brush caps.
C1-9— After removing the tangled hair or
dirt at both ends of the main brush,
reinstall it, press on the main brush
cover to lock it in place.
Notes:
• Main brush should be wiped down with a wet cloth
and left to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
Side Brush
C2
* Clean monthly and replace every 3-6 months.
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
Omnidirectional Wheel
C3
* Clean as required.
C3-1— Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
Note:
The omnidirectional wheel bracket cannot be removed.
C3-2— Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
11
Main Wheels
C4
* Clean monthly.
Clean the main wheels with a soft, dry cloth.
Dustbin and Washable Filter
C5
* Clean every week and filter should be replaced every
6-12 months
C5-1— Press the dustbin latch and slide the
dustbin backwards.
C5-2— Remove the washable filter and
empty the dustbin.
C5-3— Fill the dustbin with clean water.
Gently shake the dustbin, and then
pour out the dirty water.
Note: To prevent blockage, only use clean water without
any cleaning liquid.
C5-4— Rinse the washable filter repeatedly
and tap it to remove as much dirt as
possible.
Do not touch the surface of the filter with your
Note:
hands, brush, or hard objects to avoid potential damage.
C5-5— Leave the dustbin and the washable
filter to dry and reinstall them.
Robot Sensors
C6
* Clean every month
Use a soft, dry cloth to wipe all sensors,
including:
C6-1—Dock Locator
C6-2—Wall Sensor
C6-3—Four Cliff Sensors
Mop Cloth
C7
* Clean after each use and replace every 3 to 6 months