Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE DISHWASHER
Case 2. With disposal
With disposal
3.
Check the size of the sink's drain hose
does not fit onto the drain hose connector of the sink, use an adaptor purchasable at a plumbing/hardware supply
store.
Slide a hose clamp over the end of the drain hose. Attach the drain hose to the sink connector, slide the hose
4.
clamp to the end of the hose, and then tighten the hose clamp.
Note : You must use a hose clamp. Failure to do so may cause water leakage.
5.
If there is no air gap, make sure to hang. the middle of the drain hose well above the sink cabinet base to prevent
backflow (see Figure 13 on the next page).
6.
When drilling a hole for the drain hose on the cabinet wall, take caution not to damage the drain hose by sharp
edges of the hole. On wooden walls, use sand paper to soften the edges.On metal walls, use insulation tape or
duct tape to cover the sharp edges around the hole.
7.
Take caution not the damage the drain hose when installing the dishwasher on the floor, wall,or cabinet.
To prevent leaks or drainage problems, make sure the drain hose is not damaged, kinked,or twisted.
8. Do not cut the wrinkled area of the drain hose to fit the size. When arranging the drain hose, take caution not to
contact on sharp edges of the cabinet or under-sink.
Be careful when cutting off the end of the drain hose as there is a risk of injury. Clean around the sink's drain
connection so that it does not damage the hose. Check for any foreign items in the drain hose and remove
them.
When arranging the drain hose, make sure the drain hose is not cut, torn, or broken by any sharp edges of
the floor, the product itself, or the cabinet. A damaged drain hose causes a leak.
Disposal with an air gap
Drain hose2
connector(21mm- as shown in Figure 11
below). If the end of the drain hose
Publicité
