Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE DISHWASHER
New installation
If the dishwasher is a new installation, most of the installation work must be done before the dishwasher is
moved into place.
Replacement
If the dishwasher is replacing an old dishwasher, you must check the exising dishwasher connections for
compatibility with the new dishwasher. Repace the existing connections as necessary.
Step 2 Select The Best Location For The Dishwasher
The following criteria are important to ensure the best location for the dishwasher:
The location must have a solid floor that is able to support the weight of the dishwasher.
The location must be near a sink with easy access to the water supply, drain, and electrical outlet.
For the drain to operate properly, the dishwasher should be installed within
The location must let you load your dishes into the dishwasher easily.
The location must have sufficient space for the dishwasher door to open easily and provide
enough space between the dishwasher and the cabinet sides (at least 0.1 in (2 mm)).
If the dishwasher is installed in a comer, ensure that the side of the dishwasher is more than 2 in (50 mm) from
the wall or cabinet to its right or left.
The wall at the back must be free of obstructions.
If this is a new installation, follow these steps:
1. Using a hole saw, cut a hole into the side of the cabinet that hold the sink as shown in Figure 1-1 below.
2. If the base inside the sink cabinet is raised above the kitchen floor and is higher than the connections on
the dishwasher, make a hole in the base inside the cabinet and in the cabinet side as shown in Figure 1-2.
Depending on where your electrical outlet is, you may need to cut a hole in the opposite cabinet side.
The hole for the water supply line, drain hose and
power cables.
9.8 ft (3 m) of the sink.
Publicité
