Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE DISHWASHER
Step 7 placing The Dishwasher And Connecting The Hot Water
Supply Line
1. Adjust the three leveling legs at the bottom of the dishwasher after measuring the height of the cabinet
opening from under the countertop to the floor. (See Step 8, Leveling the Dishwasher.)
2. Locate the hot water supply line and the power cable.
3. Place the dishwasher so that the power cable is in the right channel of the base of the dishwasher. Use
standard duct tape or cable ties to secure the electrical cable to their adjacent channels in the base. This
can prevent the electrical cable from being squeezed when you push the dishwasher into place.
4. Pull the drain hose through the hole in the sink cabinet side wall. Keep it free of kinks.
5. Make sure the hot water supply line is not twisted, and then connect the hot water supply line to the elbow
joint.
6. Slide the dishwasher carefully into the installation space. If possible, gently pull any excess lengths of water
supply line, drain hose, or power cable back as you move the dishwasher. Get a second or third person to
help you do this if necessary.
Do not place the dishwasher on the water supply line, drain hose, or power cable.
Also, make sure they are not folded or twisted.
Hotwatersupplyline
Drain hose1
Drain hose2
Drain Hose2
Rubber connector
Teflon tape or sealing compound
90° Elbow
Inletvalve
Do not overtighten the 90° Elbow.
Doing so may damage the water inlet
valve and cause a water leak.
Hose clamp on the gray area
Publicité
