Publicité
Les langues disponibles
Les langues disponibles
Step 8 Leveling The Dishwasher
1. Open the door and place the level against the top of the tub on the inside
and check if the the dishwasher is level.If it is not level, rotate the leveling
legs at the bottom front of the dishwasher until the dishwasher is level.See
the first note below for instructions on adusting the height of the front legs.
2. Use the level to check if the dishwasher is level front to back, as shown in the
figure to the right.If the dishwasher is not level front to back, adjust the height
of the rear leg until the dishwasher is level.See the second note below for
instructions on adusting the the rear leg.
3. Open the door of the dishwasher andcheck if both the tub and
door clearancesare correct.If not, rotate the leveling legs on the
bottom front of the dishwasher.You can also check this by placing
a levelagainst an inside front vertical surface ofthe tub.
If the leveling legs are rotated to the right (counter clockwise), they are
lossened and the front of the dishwasher is raised. And the maximum
height be raised is about 50mm. If they are rotated to the left (clockwise),
they are tightened and the front of the dishwasher is lowered.
Before you move the dishwasher for installation, make sure to adjust the height of the legs so the legs are as
short as possible. This prevents the legs from breaking. Level the dishwasher by adjusting the height of the legs
after you have the dishwasher in place.
When you prepare to move the dishwasher for installation, you should put your hand under the basement, this
prevents your hand from injuring.
Publicité
