Olimpia splendid DOLCECLIMA Silent 12 Instructions Pour L'installation, L'emploi Et L'entretien page 72

3.11.a - Silent function (except hp version)
a. this mode can be selected in Cooling mode only (if turBo is not enabled) by pressing SW1 on the
control panel until symbol SPeaKer
b. it sets the internal fan speed and the external fan speed (except HP version) to minimum speed.
3.12 - FUNCTIONING WITH TIMER
this mode enables a delayed switch on or switch off operation to the overall unit. the time delay can
be set, enabled and cancelled from both the remote control and the control panel
3.12.a - Setting switch-on timer from remote control
a. after switching on the unit, select the operating mode, the desired temperature and the ventilation speed
with which the unit will activate automatically as programmed. then set the machine into Stand-by.
b By pressing B8, set the desired time delay (from 1 to 12 hours) after which the unit will switch on (starting
from timer confirmation).
c. if no button is pressed within 5 seconds the timer setting function will terminate automatically.
Confirm the desired delay time by pressing B10. The remote controller display shows the delay countdown
to the switch on operation.
d. When the delay time set has elapsed, the unit switches on with latest selected settings.
e. to cancel the delayed switching on, press B10 again.
3.12.b - Setting switch-off timer from remote control
a. With the unit in any working mode, press B9 to set the desired time delay (from 1 to 12 hours) after which
the unit will switch OFF (starting from timer confirmation). Each following B9 key operation increases the
delay time value by 1 hour.
b. if no button is pressed within 5 seconds the timer setting function will terminate automatically.
Confirm the desired delay time by pressing B10. Then the remote controller display shows the delay
countdown to the switch off operation. When the delay time set has elapsed, the overall unit switches
off.
c. to cancel the delayed switching on, press B10 again.
3.12.c - Setting switch-on timer from control panel
a. after switching on the unit, select the operating mode, the desired temperature and the ventilation speed
with which the unit will activate automatically as programmed. then set the machine into Stand-by.
b. Press SW3 to enable the desired time delay setting.
EN - 28
appears on the control panel display.