Publicité
Les langues disponibles
Les langues disponibles
P3500
INTRODUCTION
Thank you for purchasing the DEWALT P3500 low velocity powder actuated tool. This
tool will provide you with excellent performance provided the steps for proper operation
and maintenance are followed. Powder actuated fastening systems can provide a cost
effective method of attaching fixtures for light duty, static load conditions. The systems
provided by DEWALT consist of specially designed fasteners, installation tools, and powder
loads, which are designed to function in combination to provide optimum performance.
While powder actuated tools can provide one of the fastest and economical means of
fastening, they can also be dangerous if they are not operated properly.
Prior to operating the P3500 tool, you must be properly trained in the operation and
maintenance of this tool and be issued a DEWALT Qualified Operator Card. When using
the tool, you must have this card in your possession. As part of the training process,
you should read and understand the contents of this instruction manual especially the
safety precautions.
Powder actuated tools may be operated only by properly trained operators as
described in ANSI Standard A 10.3, Safety Requirements for Powder Actuated
Fastening Systems. For complete tool operation details, contact your local DEWALT
Branch office or distributor for training.
Remember, safety begins with you! It is your primary responsibility when operating
this tool. Failure to follow the proper operating, maintenance, and safety procedures
can result in serious injury or death to yourself or bystanders. In addition to the training
provided, you should be familiar with any local, state, and federal regulations. If you
have any questions that are not covered in this manual, contact your local DEWALT
Branch office or distributor.
SIZE RANGE:
1/2" to 3" pin lengths, .27 caliber powder loads
TOOL DESCRIPTION:
The P3500 is a low velocity, semi-automatic .27 caliber tool which can be used to install
.300 head drive pins, 8mm head drive pins and 1/4"-20 threaded studs, up to 3" in
total length. The P3500 is designed for high speed and repetitive volume applications.
TECHNICAL DATA
TOOL BODY
Precision Cast Aluminum
LOAD TYPE
.27 Caliber Strip
.300 Head Drive Pin, 8mm Head Drive Pin, Ballistic Point Drive Pin, 1/4"-20 Threaded Stud
P3500 SELECTION GUIDE
CAT #
52000-PWR
52106-PWR
52108-PWR
52110-PWR
52120-PWR
52112-PWR
52122-PWR
Piston for Installing 8mm Head Drive Pins
PIN LENGTH
1/2" to 3"
TOOL WEIGHT
5 lbs.
PIN TYPE
P3500 Tool (Deluxe Kit):
Tool, Spall Guard, 5mm Allen Wrench, 2 Annular Balls,
2 Sear Clips and Case
Piston Ring for the P3500
Guide 2/F-3 for the P3500
Base Plate 2/S-13 for the P3500/PA3500
Shear Clip for the P3500/PA3500
Piston Stop for the P3500/PA3500
Steel Annular Ball for the P35s/P3500/PA3500
TOOL LENGTH
13-5/8"
POWER LEVEL
Brown(2), Green(3), Yellow(4), Red (5)
DESCRIPTION
EN
2
CTN
1
1
1
1
1
1
1
Publicité
