Eurosystems MLT02 Mode D'emploi page 24

TROUBLESHOOTING
Before performing any maintenance and clearing work operation , please take the spark-plug cap off.!
EN
FAULT
The engine does not start
The engine power goes down
The tines are not rotating (just for rotary cultivator with
cultivator)
The grass cut is irregular (just for rotary cultivator with
mower)
The cutting bar does not work or the wheels are not turning
In case you are not able to remedy the defect/damage according to a.m. table, please contact an authorized service center only .
24
FAULT CLEARANCE
Check the fuel level, if necessary refuel.
Check the throttle to be on START position.
Check the spark-plug connector to be properly attacched.
Check the spark-plug condition and if necessary replace it.
Check the fuel valve to be in the opened position( only for the models showing
such feature).
The air filter is dirty – please clean it.
Check if any stone or soil/vegetation residue is stopping the tines rotation, in case
clean them.
Adjust the transmission cables registers.
Check the tines to be fasten to the shaft.
Check the transmission belts position and condition : realign position and/or
replace them.
sharpen or replace the cutting blade
adjust the cutting bar clearance
adjust the cutting bar cable
check the wheels to be fasten to the shaft
check the position and the transmission belts position and condition : realign
position and/or replace them.