Signature STI2B/2 Manuel D'utilisation page 51

INSTALLATION
Installation in cabinet or above over
Attention:The dimension of the air inlet must be:290*10mm.
Carry our all cutting of the unit and work surface then carefully remove
shavings
WARNING
The kitchen units that are in direct contact with the appliances must be may
heat-proof(min.800)
The appliance can be installed on a work surface with a thickness of 40 mm
Carry our all cutting of the unit and work surface then carefully remove
shavings or sawdust before inserting the appliances.
To ensure a correct ventilation of the hob please comply with the
dimensions shows in above figures .
Make sure the surface is level and square and that no part interferes with the
space required for installation.
Prepare the cut as indicated(see installation dimensions).
EN-16