GYS PLASMA CUTTER 25 K Mode D'emploi page 17

MADE IN FRANCE
• The machine protection level is IP21, which means :
- Protection against acess to dangerous parts from solid bodies of a ≥12.5mm diameter and,
- Protection against vertically falling drops.
The power cables, extensions and welding cables must be fully uncoiled to prevent overheating.
The manufacturer does not incur any responsability regarding damages to both objects and persons that result from an incorrect
and/or dangerous use of the machine .
MAINTENANCE / RECOMMENDATIONS
Ensure the machine is unplugged from the mains, and wait for two minutes before carrying out maintenance work. DANGER High
Voltage and Currents inside the machine.
Maintenance should only be carried out by a qualified person. Annual maintenance is recommended.
1 - Air filter maintenance (35KF / 31 FV) :
• It is necessary to periodically purge the air filter. In order to do so, loosen the grey tap located under the tank and press it to start the purge. Tighten
the tap when finished.
• Disassembly :
- Unplug the air supply.
- Unscrew the tank.
- Pull the cube downwards and then put it down.
- The filtering part is white, clean or replace if necessary.
2 - Periodical maintenance:
• Periodically remove the cover and dust with an air gun. You are advised to have the electrical connections checked by a qualified person, with an
insulated tool.
• Regularly check the condition of the power supply cable. If the power cable is damaged, it must be replaced by the manufacturer, an after sales
service or a qualified person to prevent danger.
• Do not obstruct the machine's air intake, to allow air circulation.
• Check that the torch does not have any cracks or exposed wires.
• Check that the consumables are installed properly and not worn.
• Do not use this equipment to thaw pipes, to charge batteries, or to start any engine.
INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorized by the manufacturer should perform the installation of the cutting equipment. During set up, the operator must
ensure that the machine is unplugged. Connecting generators in a series or a parallel circuit is forbidden.
MACHINE SUPPLIED WITH
The accessories supplies with the machine are to be used only with the same models.
HARDWARE DESCRIPTION (FIG-1)
1- Control board
2- Earth cable connector (35KF) / Earth cable
3- Torch
4- Manometer. (31FV)
CONTROL BOARD (IHM) (FIG-2)
1- Power indicator (green)
2- Thermal protection and over current protection indicator (yellow)
PLASMA CUTTER 25 K / 35 KF / 31 FV
CUTTER 25 K
Ref. 030947
4 m
2 m - 10 mm²
-
Pneumatic fittings
CUTTER 35 KF CUTTER 31 FV
Ref. 031036 Ref. 030985
-
8 mm + 10 mm
5- Air regulator (air pressure adjustment) (31FV)
6- Compressed air connector
7- Air filter (35KF / 31FV)
8- Power supply cable
3- Error indicator (red) (35KF)
4- Current setting
EN
17