Rowenta RWAC9000C Mode D'emploi page 19

If you wish to operate the appliance with no need to empty the water tank, please:
• Remove the drain cap and rubber plug and retain for future use.
• Connect one end of the drain tube supplied to the bottom drainage point and locate the other end into a drain.
Continuous drainage
When you need operating this appliance in high humidity, during the dehumidification
or cooling mode, connect the drain tube to this appliance.
• Remove the drain cap from the upper drainage point.
• Connect one end of the drain tube onto the drainage point and
extend with extra water tube (not supplied) if needed.
• Place the other end of the drain tube in a normal drain. Make sure
that the tube is free from twists and bends.
NOTE: The drain must be at or below the outlet level.
CLEANING AND MAINTENANCE
Cleaning the housing
Clean the housing with a slight damp cloth.
Never use chemical or abrasive cleaning agents.
Cleaning the filters
• The air conditioner is equipped with two filter to remove dust particles:
A filter in the upper air inlet.
A filter in the lower air inlet.
• Remove the upper grille and then take out the upper filter which is behind the grille.
• Loosen a screw on the lower grille and then remove the lower filter.
• The filter should be cleaned regularly. Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt
from the filter and then rinse thoroughly under running water. Dry thoroughly before replacing.
NOTE: Never use the air conditioner without the filter.
Storage
• Drain all water in the appliance before completely
operating the appliance on fan mode for a few hours,
to thoroughly dry the inside of the appliance.
• Clean the filter.
• Wrap the power cord and then insert the power plug
into the power plug sockets at the rear of the appliance.
• Remove the batteries from the remote control.
• Place the appliance in a dry place.
UPPER FILTER
REMOVE THE SCREW, THEN TAKE
THE LOWER FILTER OUT.
EN
POWER PLUG SOCKETS
19