Thermador Professional HPIN54WS Instructions D'installation page 15

Electrical wire routing and connection
Notes
BSH is not responsible for wiring errors during
¡
installation. Installation wiring errors are not covered by
the Statement of Limited Product Warranty.
Refer to the wire diagram included with the appliance.
¡
Remove the three (3) short screws from the junction
1.
box cover and remove the cover.
Connect the power supply wires to the hood wires in the
2.
following order: black to black, white to white, and green
wire to green ground screw on chassis. Use spring type
wire nuts.
Wire nuts should be spring type wire nuts rated for a
minimum of two (2) #18 gauge wires and maximum of
four (4) #14 gauge wires, UL & CSA rated to 600V and
302°F (150°C) .
Replace the junction box cover and secure it with the
3.
previously removed 3 short screws.
Connecting the extension cable (optional)
EXTNCB25W 25 ft. remote and in-line blower extension
cable.
Parts included:
1.
– 25 ft. cable (1)
– Adapter cables (2) - not needed for all models
Route the hood's internal blower harness through the
2.
strain relief.
Connect the 25 ft. extension cable to the blower
3.
harness outside the hood.
A Connects to the hood
B Connects to a remote or in-line blower
Note: Cutting of the connector will void the warranty of
the appliance.
The blower extension cable is compatible with the
following in-line and remote blowers:
Blower
Remote blower
In-line blower
5.5 Make-up air damper relay switch
(optional)
Local codes may require the use of an additional backdraft
and/or make-up air damper. Contact your local HVAC
professional for specific requirements.
This hood provides a relay switch to connect a make-up
air damper (120V max). Installations will vary according to
the location in the home where the appliance is installed
and the damper used. Use the following illustration as
guidance for your installation. Always comply with local
code requirements.
Connecting the make-up air damper relay switch
Access the hood's wiring.
1.
Installation en-us
Model
VTR2FZ
VTI2FZ
15