Laserworld Club CS-12.000RGB FX MK2 Mode D'emploi page 12

Manual: CS-8000RGB FX MK2 | CS-12.000RGB FX MK2
Master Setting
The „uAST" menu allows for the activation and deactivation of the Master mode for the laser.
If the laser is set to Master > On, then it can be used as Master device in a Master-Slave setup.
See more in „4.3. Master-Slave".
Press „Enter" to change the settings. Use the „Up" / „Down" button to change the selection.
Confirm with „Enter".
Safety Setting
The „bEAu" menu can switch the beam block safety on and off. The beam block safety
prevents that very intense, single beams can be displayed. It is highly recommended to not
switch this feature off. Switching off the beam block safety is at your own risk! Lasers with
switched off beam block safety may only be used in safe areas.
Always respect the local laws!
Press „Enter" to change the settings. Use the „Up" / „Down" button to change the selection.
Confirm with „Enter".
Orientation Setting
The „InuE" menu controls the orientation of the projection. You can invert the projection and
flip it to match the orientation of the laser with the content.
Press „Enter" to change the settings. A test picture is shown to represent the currently set
orientation. Use the „Up" / „Down" button to change the selection, and confirm the selection
with „Enter" to change the test picture projection
Press „Exit" to return to the settings menu.
English
page 12 / 37