Ego Power+ TR4200 Manuel De L'opérateur page 9

2. Insert the posts into the mounting holes of the tractor as shown (Fig. 9).
3. Lift the top cover assembly above the posts and lower it so that the upper tips of the posts are inserted into the top
cover assembly as shown (Fig. 10). To simplify the process, it is recommended that two persons perform this step.
10
Insert two lock pins into the holes and secure them with the retention pins (Fig. 11).
4. Hold the crossbar between the posts to align the two mounting holes on both ends of the crossbar with the two
lower mounting holes of each post. Pre-install four hexagon head bolts on both sides and finger-tighten the bolts
and nuts (Fig. 12).
5. Securely tighten all four bolts on both sides by an impact wrench with a 1/2'' (13mm) socket (not included) (Fig. 13).
12
Crossbar
Hexagon head bolts
11
13
GRASS BAGGER KIT — ABK4200T
Impact Wrench
9