EINHELL 40.204.20 Instructions D'origine page 18

•
Warning! Observe the information supplied
by the tire manufacturer and the vehicle ma-
nufacturer relating to the recommended tire
pressure.
•
Warning! This equipment is not calibrated!
For a calibrated measurement value, check
the actual tire pressure using a calibrated me-
ter after you have inflated the tires yourself,
e.g. at a petrol station.
•
Just before it is switched off, the pressure
which is shown in the display can be 0.05 –
0.2 bar higher than the preselected pressure,
because of overpressure in the air hose.
•
Allow the compressor to cool down for about
5 minutes after every 5 minutes of operation
in order to prevent overheating.
6.2 Low-pressure blower operation
(Fig. 1a, 4)
6.2.1 Defl ating (Fig. 2, 4)
•
To draw air out of large-volume objects until
they are empty (e.g. deflating an air mattress,
etc.), connect the air hose (3) to the deflate
connection (13). Use the adapter (21) if ne-
cessary.
•
Connect the air hose to the object you want
to deflate.
•
Switch on the tool by pressing the pushbutton
for low-pressure mode (12).
•
Switch off the equipment once the object has
been sufficiently deflated.
6.2.2 Infl ating (Fig. 2, 4)
Warning! When using the equipment to infl ate
objects, check the information and safety inst-
ructions provided by the manufacturer of these
objects.
•
To inflate objects with a large volume (e.g.
inflating an air mattress, etc.), connect the air
hose (3) to the inflate connection (4).
•
Connect the air hose to the object you wish to
inflate. Use the adapter (21) if necessary.
•
Switch on the tool by pressing the pushbutton
for low-pressure mode (12).
•
Switch off the equipment once the object has
been sufficiently inflated.
6.3 Sleep mode (Fig. 2)
The equipment will switch to sleep mode if it is
not used for 5 minutes. To reactivate the equip-
ment, press the „Unit overpressure/wake-up"
button (15).
Anl_PRESSITO_18_25_SPK13.indb 18 Anl_PRESSITO_18_25_SPK13.indb 18
GB
7. Cleaning, maintenance and
ordering of spare parts
Hazard!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
Tip! For good results we
recommend high-quality
accessories from
www.kwb.eu
welcome@kwb.eu
- 18 -
!
15.12.2022 14:56:55 15.12.2022 14:56:55