Pentair Flotec MAXIVORT 50-36/14 Manuel D'utilisation Et D'entretien page 10

EN
USE AND MAINTENANCE MANUAL
CHAPTER 2
LIMITATIONS
PENTAIR FLOTEC MAXIVORT series electropumps are suitable to pump dirty water containing suspended solid parti-
cles. These pumps can be used both for permanent and temporary installations and in particular to empty collection
basins containing dirty or waste waters.
WARNING
The pump cannot be used for sea water and inflammable, corrosive, explosive or dangerous liquids.
WARNING
Verify that the electropump never runs without liquids.
DANGER - ELECTRIC SHOCK RISK
Make sure people do not come into contact with water when the pump is connected to the mains.
TECHNICAL DATA
Mains voltage / frequency
Absorbed power
Type of protection / Insulation class
Delivery fitting
Maximum flow rate
Maximum head
Maximum depth of Maximum depth of immersion
Power cable
Weight
Maximum dimension of pumped solid particles
Maximum temperature of the pumped fluid (in servizio continuo)
Maximum number of starts per hour (uniformly distributed)
Minimum priming level
Minimum suction level
Stop level
Sound pressure level (Lpa) equal to or less than 70 dB(A)
Sound emission values obtained in conformity with the EN 12639 standard
Motors used in these products are exempted from efficiency requirement in accordance with Article 2.2 (a) of the
Regulation (EU) 2019/1781
The minimum priming level corresponds to a condition in which the delivery mouth is completely submersed.
It is also advisable to check the maximum dimension of particles recommended for the pump and take the neces-
sary measures to prevent the fish from being sucked into the pump.
8
MAXIVORT 50-36/14
230 V ~ 50 Hz
2.200 Watt
IP 68 / B
59,61 mm (2" F)
36.000 l/h
14 m
7 m
10m H07 RN8-F
17,5 Kg
50 mm
35° C
30
115 mm
55 mm
238 mm