Digital Inputs; Outputs; Control Outputs; Supply Voltage - PMA KS 98-1 Mode D'emploi

9499-040-44318
INP 5: DC current and DC voltage (difference input, INP 6: resistance transducer and DC current).
INP 3 and INP 4 (option C): DC current (dependent on equipment with modular option C).
3.2

Digital inputs

Opto-coupler for 24 V DC, current sink to IEC 1131 type1 (Logic "0" = -3...5 V, logic "1" = 15...30 V,
approx. 5 mA).
di1 and di2: without CANopen I/O in all versions.
di3...di7: option B; di4...di12: option C (dependent on equipment with modular option C).
3.3

Outputs

Relay contact rating: 500 VA (resistive load), 250 V, 2 A at 48...62 Hz (500VA resistive load' .
OUT1, OUT2: relay or current/logic dependent on version. OUT4, OUT5: relay.
OUT 3 (option C): current/logic (dependent on equipment with modular option C).
3.4

Control outputs

Opto-coupler, "grounded load" with common positive control voltage, power 18...32 V DC ß 70 mA.
do1...do4: option B, do5 and do6: option C (dependent on equipment with modular option C ).
3.5

Supply voltage

Detailed technical data are given in data sheet KS98-1 (9498 737 52313).
90...260V AC, 48...62 Hz, power consumption approx. 12,3 VA / 7,1 W (maximum equipment).
3.6

Galvanic isolations

Galvanically isolated connection groups are marked by lines in the connecting diagram.
w Measuring and signal circuits: functional isolation up to a working voltage £ 33 VAC / 70 VDC
against earth (to DIN 61010-1; dashed lines).
w Mains supply circuits 90...250 VAC, 24 VUC: safety isolation between circuits and against earth up
to a working voltage £ 300 Vr.m.s. (to EN 61010-1; full lines).
w Instruments with I/O extension modules (KS98-1xx-x3xxx and KS98-1xx-x4xxx): sockets 1-2 and 3-4
are galvanically isolated from each other and from other signal inputs/outputs (functional isolation).
3.7

Electrical safety

The insulation of the instrument meets standard EN 61 010-1 (VDE 0411-1) with contamination de-
gree 2, overvoltage category III, working voltage 300 V r.m.s. and protection class I.
Galvanically isolated connection groups are marked by lines in the connecting diagram.
33
Important technical data
Digital inputs