Publicité
Les langues disponibles
Les langues disponibles
Unit Storage:
1: Unscrew the drainage cover, unplug the water plug, and
discharge the water in the water pan into other water containers or
directly tilt the body to discharge the water into other containers.
2: Turn on the machine, adjust it to low-wind ventilation mode, and
maintain this state until the drainage pipe becomes dry, so as to
keep the inside of the body in a dry state and prevent it from
mildewing.
3: Turn off the machine, unplug the power plug, and wrap the power
cord around the wrapping post; install the water plug and the
drainage cover.
4: Remove the exhaust pipe and keep it properly.
5: Cover the air conditioning with a plastic bag. Put the air
conditioning in a dry place, keep it out of the reach of children, and
take dust control measures.
6: Remove batteries of the remote control and keep them properly.
Note: ensure that the body is placed in a dry place and keep all
machine components properly.
14
Troubleshooting
Do not repair or disassemble the air conditioning by yourself.
Unqualified repair will cause damage to users or their properties.
Problems
Reasons
There is no electricity.
The overflow indicator
displays "FL".
The ambient temperature
is too low or too high
The air
conditioning
does not
work.
In cooling mode, the room
temperature is lower than the
set temperature; in heating
mode, the room temperature is
higher than the set temperature.
In dehumidification mode, the
ambient temperature is low.
There is direct sunlight.
Doors or windows are open;
there are a lot of people; or in
The cooling
cooling mode, there are other
effect is not
sources of heat.
good
The filter screen is dirty.
The air inlet or outlet is
blocked.
The air conditioning is not
Big Noise
placed on a flat surface.
Compressor
Overheat protection starts.
does not work.
Solutions
Turn it on after connecting it
to a socket with electricity.
Discharge the water inside.
Recommend to use the
machine in at the
temperature of 7-35
C
O
(44-95
F).
O
Change the set
temperature.
The machine is placed in
a room with an ambient
temperature of greater
than 17
C (62
F).
O
O
Pull the Curtain.
Close doors and
windows,
and add new air
conditioning.
Clean or replace the
filter screen.
Clear obstructions.
Put the air conditioning
on a flat and hard place
(to reduce noise).
Wait for 3 minutes until the
temperature is lowered, and
then restart the machine.
15
Publicité
