Costway FP10346 Mode D'emploi page 6

III. A Variety of Protection Functions
3.1 Frost Protection Function:
In cooling, dehumidifying or energy-saving mode, if the temperature
of the exhaust pipe is too low, the machine will automatically enter
protection status; if the temperature of the exhaust pipe rises to a
certain temperature, it can automatically revert to normal operation.
3.2 Overflow Protection Function:
When water in the water pan exceeds the warning level, the
machine will automatically sound an alarm, and the "FULL" indicator
light will flash. At this point, you need to move the drainage pipe
connected the machine or the water outlet to sewer or other
drainage area for drainage(refer to Drainage Instructions at the end
of this chapter for detail) for details. After the water is emptied, the
machine will automatically return to the original state.
3.3 Automatic Defrosting (cooling mode has this function):
The machine has automatic defrosting function.
Drainage Instructions
1. Manual drainage:
1) When the machine stops after the water is full, turn off the
machine power and unplug the power plug.
Notes: Please move the machine carefully, S0 as not to spill the
water in the water pan at the bottom of the body.
2) Place the water container below the side water outlet behind the
body.
3) Unscrew the water plug, the water will automatically flow into the
water container.
Note:
1. Keep the water plug properly.
2. During drainage, the body can be tilted slightly backwards.
3. If the water container cannot hold all the water, before the water
container is full, stuff the water outlet with the water plug as soon as
possible to prevent water from flowing to the floor or the carpet.
4) When the water is discharged, stuff the water plug up.
12
Notes:
1. Restart the machine after
the water plug is installed,
otherwise condensate water
of the machine will flow to the
floor or the carpet.
2. Continuous drainage
(Optional) (only applicable to
dehumidifying mode), as
shown in figure:
1) Unplug the water plug on.
2) Set the drainage pipe into
the water outlet.
3) Connect the drainage pipe
to the bucket.
Rubbar Stopper
Maintenance
Cleaning: before cleaning and maintenance, turn off the machine
and unplug the plug.
1.Clean the surface
Clean with surface of machine with a wet soft cloth. Don't use
chemicals, such as benzene, alcohol, gasoline, etc.; otherwise, the
surface of the air conditioning will be damaged or even the whole
machine will be damaged.2.Clean the filter screen If the filter screen
is clogged with dust, and the effectiveness of the air conditioning is
reduced, be sure to clean the filter screen once every two weeks.
2.1: Clean the upper filter screen frame
1)Clasp the wedging block of the EVA filter screen frame with
hands.
Force down from the outside to remove the EVA filter screen frame.
Unscrew four screws fixing the EVA filter screen and the rear
housing to remove the EVA filter screen (as shown in the above
figure) .
2)Put the EVA filter screen into warm water with neutral detergent
(about 40℃ / 104℉) and dry it in the shade after rinsing clean.
1
2
Exhaust water
tube
13