Siemens SIMATIC HMI IFP V2 Instructions De Service page 91

Table des Matières

Publicité

FCC et Canada
USA
Federal
Communications
Commission
Radio Frequency
Interference
Statement
Shielded Cables
Modifications
Conditions of
Operations
CANADA
Canadian Notice
Avis Canadien
Responsible party for Supplier's Declaration of Conformity in the USA
Siemens Industry, Inc.
Digital Factory - Factory Automation
5300 Triangle Parkway, Suite 100
Norcross, GA 30092
USA
Mail to: (amps.automation@siemens.com)
IEC/UL 61010-2-201
Les appareils répondent aux exigences et critères de la norme IEC/UL 61010, Règles de
sécurité pour les appareils électriques de mesurage, de régulation et de laboratoire -
Partie 2-201 : Exigences spéciales pour les appareils de commande et de régulation.
CEI 61131
Les appareils satisfont aux exigences et critères de la norme CEI 61131-2, Automates
programmables, partie 2 : Exigences des équipements et contrôles/essais.
RCM AUSTRALIA/NEW ZEALAND
Ce produit satisfait aux exigences de la norme EN 61000-6-4 normes génériques - Norme sur
l'émission en zone industrielle.
This product meets the requirements of the standard EN 61000-6-4 Generic standards –
Emission standard for industrial environments.
IFP V2, IFP V2 PRO, IFP V2 ETH
Instructions de service, 08/2021, A5E46641424-AC
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003 (A).
Cet appareil numérique de la classe A est conforme à la norme NMB-003 (A)
du Canada.
Caractéristiques techniques
7.1 Certificats et homologations
91

Publicité

Table des Matières
loading

Table des Matières