Publicité
Les langues disponibles
Les langues disponibles
fridge may also be affected.
DEFROSTING
Defrost the refrigerator when the frost is more than 3mm thick.
To defrost, simply press the defrost button on the temperature control knob.
Be sure to keep the drip tray in place.
The refrigerator will restart automatically when defrosting ends.
Empty water from the drip tray after defrosting.
DOOR CONVERSION
If you need to hinge your door on the opposite side it is recommended that you call your local authorised service agent to make this conversion
or ask a technician.
Before you reverse the door, you should ensure the appliance is unplugged and empty. It is recommended to use a crosshead screwdriver and
a spanner (both not supplied).
1. Remove the hole covers from the top of the door and top panel.
2. Remove the upper hinge cover.
3. Remove the screws that hold the upper hinge and remove the upper hinge.
4. Lift the door and place it on a padded surface to prevent it from being scratched.
5. Remove the screws that hold the lower hinge and then remove the lower hinge.
6. Unscrew the screw and remove the foot. Then transfer and fix it to the opposite side.
7. Remove the bolt-pin from the lower hinge and install the lower hinge to the opposite side with the screws.
8. Install the bolt-pin to the lower hinge.
9. Fit the door onto the lower hinge.
10. While holding the door in the closed position, secure the upper hinge in the top frame of left side with screws.
Make sure the door is properly aligned on the appliance before tightening the screws.
11. Attach the hole covers to the top panel and the top of the door.
TIPS FOR SAVING ENERGY
For the most energy efficient use of your appliance:
Ensure your fridge has adequate ventilation as recommended in the installation instructions.
Allow warm food and drinks to cool down before placing in the appliance.
Keep door openings to a minimum.
Open the appliance as briefly as possible.
Regularly defrost the fridge to remove the layer of frost.
Ensure that the door is always closed properly.
OPERATING NOISES
Normal noises
Motors are running.
Refrigerant is flowing through the tubing.
CLEANING AND MAINTENANCE
Do not use abrasive cleaning agents or
solvents.
1. Disconnect the mains plug from the mains socket.
2. Take out the food and store in a cool location.
3. Clean the appliance with a soft cloth, warm water and detergent.
4. Wipe the door seal with clear water only and then wipe dry
thoroughly.
5. After cleaning reconnect and adjust the temperature control knob
as desired.
6. Put the food back into the appliance.
EN-9
Publicité
