Publicité
Les langues disponibles
Les langues disponibles
BEFORE INSTALLING THE APPLIANCE
Before connecting your fridge to the power supply, check that the voltage stated on the rating label of your appliance corresponds to the voltage in your
home. A different voltage could damage the appliance.
The plug is the only way to unplug the appliance and should therefore be accessible at all times. To turn off main power to the appliance, turn it off and
then detach the plug from the outlet.
The appliance must be grounded. The manufacturer is not responsible for damages that may occur as a result of usage without grounding.
INSTALLATION
Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e.g. a
cooker, radiator, etc.
To ensure adequate ventilation for the appliance, allow a minimum of 10 cm of airspace on each side of the cabinet.
AMBIENT TEMPERATURE
This appliance is designed to operate in ambient temperature between 16°C and 38°C. If these temperatures are exceeded, i.e. colder or warmer, the
appliance will not operate correctly. If the ambient temperatures are exceeded for long periods, the temperature in the fridge will rise above 4°C and food
spoilage may occur.
BEFORE PLACING FOOD IN THE FRIDGE
Remove all packaging.
Allow the appliance to run empty for 2 – 3 hours so the compartments can cool to the appropriate temperature.
Clean the inside of the appliance with warm water and a little liquid detergent to remove manufacturing and transportation dust.
TEMPERATURE CONTROL
The fridge is controlled with a temperature control knob located inside it, towards the upper right hand corner.
Adjust the control knob as desired to suit your individual preference.
0 is off setting
1 is cold setting
7 is coldest setting
In the off position (0) the appliance does not operate (the cooling system is switched off), but power supply is not interrupted.
The running time and temperature are affected by where the fridge is located, how often the door is opened and the temperature of the room the fridge
is located in.
When you use the appliance for the first time or after defrosting, adjust the control knob to the coldest setting for at least 2 hours before introducing food
to be stored, and then readjust to the middle setting.
MOVING YOUR APPLIANCE
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will allow the refrigeration system pressures to equalise
before restarting.
Turn off the appliance and unplug it from the mains socket. Remove all food.
Relocate and install. If the appliance has been left on its side for any length of time, leave it standing upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly and natural gas, it is explosive. Therefore you
should be careful during shipment and installation to prevent your appliance's cooler elements from being damaged. In the event of a leak caused by
damage to the cooler elements, move your fridge from open flame or heat sources and ventilate the room where the appliance is located for a few
minutes.
EN-6
Publicité
