Publicité
Les langues disponibles
Les langues disponibles
OPERATION
*Always let the appliance rest for at least 2 hours after moving it from one location to another.
Before use, check up whether the exhaust hose has been mounted properly. Plug in the appliance.
1. Power button
Press the power button to turn on the appliance. The appliance will start to work.
Press the power button again, the appliance will be turned off.
2. Mode button
Press the mode button to choose your desired working mode among fan, cooling and drying mode. The
corresponding indicator light will turn on when the specific mode is selected.
•
Fan mode
The adjustment of temperature in fan mode is not effective.
In fan mode, the room air is circulated but not cooled.
•
Cooling mode
When the room temperature is higher than the set temperature, the compressor starts to run.
When the room temperature is lower than the set temperature, the compressor stops and the fan
operates at the set speed.
Note: When the compressor is working, the unit will vibrate slightly. This is normal and harmless.
•
Drying mode
The fan runs at a low speed. The fan speed and temperature cannot be adjusted.
The compressor will stop after 8 minutes of running and then run again after 6 minutes.
3. Temperature/timer increasing button & temperature/timer decreasing button
The temperature adjustment is only effective in the cooling mode.
Press the button "
also be used for timer adjustment during timer setting. The value will be increased/decreased by 1 (℃
/hour) for each press.
Note: In cooling mode, the set temperature will be shown on the digital display; in fan or drying mode,
the room temperature will be shown on the digital display.
4. Fan speed button
Press the fan speed button to select low speed or high speed. The corresponding indicator light for fan
speed will turn on.
Note: In drying mode, the fan speed cannot be selected.
5. Timer button
Auto-ON setting
When the appliance is OFF, press the timer button, the digital display will flash "00".
-
Press the timer increasing or decreasing button to select a desired auto-ON time from 1 to 24 hours.
-
The digital display will flash for several seconds, then the timer setting is confirmed. The timer-ON
indicator light will illuminate.
The appliance will automatically turn on once the select time passed.
-
Auto-OFF setting
When the appliance is ON, press the timer button, the digital display will flash "00".
-
Press the timer increasing or decreasing button to select a desired auto-OFF time from 1 to 24 hours.
-
The digital display will flash for several seconds, then the timer setting is confirmed. The timer-ON
indicator light will illuminate. The digital display will turn back to the set temperature.
The appliance will automatically turn off once the select time has passed.
-
"/"
" to set your desired room temperature from 16℃ to 32℃. The buttons can
- 9 -
Publicité
