Mitsubishi Heavy Industries SRK20ZMX-S Manuel De L'utilisateur page 16

ON-TIMER operation
■ Operation starts 5 to 60 minutes before the set time so that the room temperature reaches the optimum temperature at the set time.
ON-TIMER operation can be set regardless of whether the air-conditioner is running or not.
Changing of set time
Set a new time by using the ON-TIMER button.
How to cancel
Press the CANCEL button to turn off the timer
display.
SLEEP TIMER + ON-TIMER operation
■ Combined timer operation of SLEEP TIMER and ON-TIMER.
Example: In the case the preferred room temperature is required at 8:00.
1
Press the ON-TIMER button.
ON-TIMER display
2
Press the " or
Every time the button is pressed, the display is switched in the order of:
0:00 0:10 0:20
Every time the button is pressed, the display is switched in the order of:
0:00 23:50 23:40
Set at 8:00.
3
Press the SET button.
The display changes from blinking to steady lighting and the setting is
complete.
The timer light (yellow) is on.
The operation stops if it is set during operation.
NOTE
• Operation starts 5 to 60 minutes before the set time.
• The timer light (yellow) goes out at the set time.
• Make sure to press the button within 60 seconds from the last opera-
tion in step 2, otherwise the setting is not completed.
• The current time is not displayed during ON-TIMER operation.
• ON-TIMER operation will not function during ALLERGEN CLEAR
operation.
Example: When it is required to stop after 3 hours and then start operation at 8:00, near the
set temperature.
■ SLEEP TIMER setting
Set by the procedures on page 13.
Set to
■ ON-TIMER operation setting
Set by the above procedure mentioned in ON-TIMER.
Set to
The setting of the lighting of the timer light (yellow) of this unit is complete.
h
• After the SLEEP TIMER set time has elapsed, the operation stops, and it starts
from 5 to 60 minutes before the ON-TIMER's set time.
• The timer light is turned off when ON-TIMER set time comes.
Changing of set time
Set a new time by using the SLEEP or ON-TIMER button.
How to cancel
Press the CANCEL button to turn off the timer display.
– 14 –
is blinking.
(TIMER)" button.
...
(Units of ten minutes)
1:00 1:10
...
23:00 22:50 (Units of ten minutes)
Page 15