Publicité
Les langues disponibles
Les langues disponibles
7
CARE AND CLEANING
Waveguide Cover
The waveguide cover is located on the right side
wall of the oven cavity. It is made from mica so it
requires special care. Keep the waveguide cover
clean to assure good oven performance. Careful-
ly wipe with a damp cloth any food spatters from
the surface of the cover immediately after they
occur. Built-up splashes may overheat and cause
smoke or possibly catch fire. DO NOT REMOVE
THE WAVEGUIDE COVER.
The Exhaust Feature
The exhaust hood feature on your microwave
oven is equipped with two metal filters which
collect grease. When the fan is being operated,
air is drawn up through the filters and is then
discharged through the venting to the outside or
through the charcoal filters if not vented to the
outside.
METAL GREASE
COOKTOP
FILTER
Reusable Grease Filters
The reusable grease filters should be cleaned
at least once a month. Never operate the mi-
crowave without the filters in place. In situations
where flaming might occur on surfaces below the
hood, filters will stop the entry of flames into the
unit.
To Remove Grease Filter
To remove the grease filter holder, pull the tab
toward the front of the oven. Repeat for the other
grease filter holder.
26 / 90 EN
METAL GREASE
LIGHT
FILTER
To remove the grease filter from the holder, pull
using the "finger hold" to assist as shown in below
image.
To Clean Grease Filter
To clean grease filters, soak and then agitate filter
in solution of hot water and detergent. Do not use
ammonia or ammonia products because they will
darken the metal. Light brushing can be used to
remove embedded dirt. Rinse, shake and remove
moisture before replacing.
To Replace Grease Filter
To replace the grease filter, slide the grease filter
into the grease filter holder. Insert the grease filter
holder into the designated area of the bottom of
the oven. Repeat for the other grease filter.
Over The Range Microwave Oven / User Manual
PULL
FINGER HOLD
Publicité
