Publicité
Les langues disponibles
Les langues disponibles
any assembly, adjustments or changing
accessories. Such preventive safet y
measures reduce the risk of starting the
tool accidentally.
accessories rated 21000
OPM or greater. Using accessories not
designed for this power tool may result in
serious personal injury and property damage.
For all work or when
changing accessories
always wear protective gloves.
preventive safety measures reduce the risk of
injury from sharp edges of the accessories.
Accessories can become very hot while
working. Danger of burns!
INSTALLING ACCESSORIES
If necessary, remove an already-mounted
accessory. (See REMOVING ACCESSORIES
below)
1. Position the accessory such that its model
number will face the oscillating tool's
accessory holder (Fig. 2).
2. Determine the desired angle of the
accessory to the tool. Accessories can
be mounted such that they are oriented
with their working edge straight ahead of
the tool, or angled to the left or right to
WORKLIGHT
16099221RZ_GOP18V-34_202303.indd 9
16099221RZ_GOP18V-34_202303.indd 9
Assembly
Disconnect battery pack
from tool before making
O n l y
u s e
B o s c h
Such
CLAMPING LEVER
FOR DEPTH STOP
DEPTH STOP
PLUNGE CUT
SAW BLADE
SANDING
SHEET
enhance usability. (Fig. 2)
3. Press the oscillating tool into the
accessory holder until the holder's
clamping jaws "snaps" into the accessory.
It is not necessary to open the accessory
release lever to install an accessory.
REMOVING ACCESSORIES
To remove accessory, open accessory release
lever, and the accessory off will be released
and ejected off of the tool.
In order to help ensure that the tool has
a solid grip of the accessory, clean the
accessory holder and accessories as
necessary with a clean cloth.
INSTALLING AND REMOVING
SANDING SHEETS
Your backing pad uses hook-and-loop backed
accessories, which firmly grip the backing pad
when applied with moderate pressure.
1. Align the sanding sheet and press it onto
the sanding backing pad by hand.
2. Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This
will promote good adhesion and helps to
prevent premature wear.
3. To change, merely peel off the old sanding
sheet, remove dust from the backing pad
if necessary, and press the new sanding
sheet in place.
ACCESSORY
RELEASE LEVER
ACCESSORY HOLDER*
DUST
EXTRACTION
SYSTEM
SANDING
PLATE
-9-
FIG. 2
3/17/2023 8:21:52 AM
3/17/2023 8:21:52 AM
Publicité
