Publicité
Les langues disponibles
Les langues disponibles
OSC004 Depth Stop Kit
(Optional Attachment)
INTRODUCTION
The OSC004 Depth Stop Kit attachment
is compatible with the Bosch GOP40-
30, GOP55-36, GOP12V-28, GOP18V-28,
G O P 1 8 V - 3 4 , M X 3 0 E , a n d M X H 1 8 0
Oscillating Tools and allows the depth of a
cut to be limited to a user-selected depth.
(FIG.A) It can also be used to provide
guidance for other types of cuts. (FIG. B)
INSTALLATION
Step 1: If an accessory has already been
installed on the tool, remove it.
Step 2: Place the bracket onto the nose
of the tool such that the clamp is
facing the rear of the tool. (FIG. C)
Step 3: Press the clamp shut. (FIG. C)
Step 4: Push the appropriate guide into
the opening in the front of the
bracket.
Step 5: Install the accessory onto the tool.
Step 6: Set the desired cutting depth using
the red button on the side of the
bracket. (FIG. C & D)
PLUNGE CUTS
• For plunge cutting using round blades,
such as "segment" blades, install the
wide stop as shown in figure D.
• For plunge-cut blades using straight
blades, install the narrow stop as shown
in figure E.
OTHER TYPES OF GUIDED CUTS
• For other types of guided cuts, install the
wide stop as shown in figure B.
D
16099221RZ_GOP18V-34_202303.indd 19
16099221RZ_GOP18V-34_202303.indd 19
Attachments
A
B
C
E
-19-
3/17/2023 8:21:59 AM
3/17/2023 8:21:59 AM
Publicité
