Siemens 9001071760 Notice D'utilisation page 16

16
Starting wellness program 2
Briefly press the wellness program button
sion. The display lights up in colour, the stored shower tempera-
ture appears in °C and the symbol
Now turn on the tap within 2 minutes and wellness program
2 commences. At first, warm water will run for 1 minute (water
temperature depends on your setting) and then 30 °C warm
water will be dispensed for 30 seconds.
2x
Tip: Wellness program 2 should be applied for several shower cy-
cles. They can be repeated as often as required.
Ending wellness program 1 or 2
Both programs will repeat until either the selected wellness pro-
gram button
than 1 minute. The temperature set before the program start in
now reactivated.
The programs can also be activated while the water is running.
1x
Changing the wellness program temperature
The preset temperature for the warm phase is 39 °C. This can be
modified in a range from 30 °C to 42 °C.
Press the wellness program button
program 1. The saved shower temperature in °C and the
symbol appears.
Keep wellness program button
select the programming function. The
1x
flash rapidly.
Use the rotary knob to set the desired temperature between
30 °C and 42 °C.
Press the wellness program button
the new value.
The selected temperature is now saved in wellness program 1.
en
is pressed once or the tap is shut off for more
twice in succes-
flashes.
once to select wellness
pressed for 3 seconds to
symbol starts to
for 3 seconds to store