Télécharger Imprimer la page

Powersmart DB8621CRX Mode D'emploi page 15

Publicité

Les langues disponibles

Les langues disponibles

Customer Service.
Warning: The blade begins to rotate as soon as the engine is started.
START THE ENGINE
To start the engine, perform the following steps:
1. Check the oil and fuel levels.
2. Press the primer bulb 3 times.
3. Engage the engine Start/Stop Control and simultaneously pull on the recoil starter. Pull on the recoil
starter handle slowly until a slight resistance is felt, then pull quickly to start the engine.
Return cord gently into the recoil starter. Never allow the cord to snap back.
4. If engine fails to start, repeat step 3.
Note: After repeated failed attempts to start the engine, please consult the troubleshooting guide before
attempting again. If problems persist, please call customer service.
Note:
on't allow the starter grip to snap back against the engine. Return it gently to prevent damage to
D
the starter
KIT HIGH ALTITUDE REPLACEMENT FOR EPAIII ENGINES
3000ft to 6000ft or 6000ft to 8000ft of elevation
At high altitude, the standard carburetor air-fuel mixture will be too rich. Performance will decrease and
fuel consumption will increase. A very rich mixture will also foul the spark plug and cause hard starting.
Operation at an altitude that differs from that at which this engine was certified, for extended periods of
time, may increase emissions.
The fuel system on this Engine or Equipment may be influenced by operation at higher altitudes. Proper
operation can be ensured by installing an altitude kit when required. See the table below to determine
when an altitude kit is required. Operating this generator without the proper altitude kit installed may
increase the engine's emissions and decrease fuel economy and performance. Kits may be obtained from
any dealer, and should be installed by a qualified individual.
Equipment *
Equipment with
engines above 80cc
*Engine, Generator Set, Pressure Washer, Walk-Behind Lawnmower, Compressor, Pump, Tiller etc.
** Elevation above sea level.
This high altitude jet is to be used at elevations above 3000 feet.
At elevations above 8000 feet, the engine/equipment may experience decreased performance, even
with the high altitude kit.
If a carburetor is replaced, the proper high altitude kit jet will need to be installed into the
replacement carburetor.
Fuel
Gasoline
15
Altitude Range**
0 – 3000 ft
3000 – 6000 ft
6000 – 8000 ft
Kit Part Number
Not Required
Altitude kit 1#
Altitude kit 2#

Publicité

loading