Publicité
Les langues disponibles
Les langues disponibles
LAWN MOWER PREPARATION
The following section describes steps necessary to prepare the lawn mower for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800)791-9458 Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the lawn mower or shorten
its lifespan.
UNPACKING
Tools required (not included): #2PH screwdriver, utility knife.
Unpack the lawn mower and all its parts, and compare against the list below. Do not discard the carton or
any packaging until the engine is completely assembled.
PACKING LIST
Side discharge chute*1
Grass Catcher*1
Cable clip*1
Spark plug wrench*1
Flange bolts M6*2
User manual*1
Funnel*1
High altitude kit *1
ATTACH LOWER & UPPER HANDLE
1. Loosen two knobs and turn the folded upper handle to match the lower handle, and tighten the knob.
2. Turn the lower handle to an angle that maches the base and tighten with two screws. (Two screws are
in the accessories bag. ）
11
Publicité
