JB Systems SM-1612 SCANMASTER Mode D'emploi page 15

ENGLISH
2. Auto Mode: You can run one or more chases at an adjustable speed. If you select
more than one chase, all chases will be run one by one. The LED of the active
chase blinks. You can use the Manual override button, see further for more
information.
a. Press the Auto/Del button to enter into Auto mode. The Auto LED turns on.
b. Select one or more chases. (pressing the same chase a second time unselects
it) The LEDs of the selected chases are lit. The active chase blinks and its name
+ active scene/bank are shown on the display.
c. Use the speed slider and Fade Time slider to adjust the speed of the chases.
d. You can use the TAP/Display button to set the speed instead. The time between
the last two taps equals the length of time between steps. This setting will stay
in effect until the speed slider is moved.
e. Press the Auto/Display button to exit Auto mode.
3. Music Mode: You can run one or more chases to the beat of the music. You can
use the internal microphone or add an external music signal. If you select more
than one chase, all chases will be run one by one. The active chase blinks. You
can use the Manual override button, see further for more information.
a. Press the Music/Bank copy button to activate Music mode. The Music LED
turns on.
b. Select one or more chases. (pressing the same chase a second time unselects
it) The LEDs of the selected chases are lit. The active chase blinks and its name
+ active scene/bank are shown on the display.
c. Press the Music/Bank Copy button again to exit music mode.
Note: You can use the fade time slider to make the movement a little smoother.
Don't add too much fade time, the music synchronization will be completely lost!
OVERRIDE FUNCTION
During playback of scenes and chases in auto and music mode, it is possible to select
one or more fixtures and manipulate their functions manually.
To do this just select the fixtures you want to lift out of the running sequence and press
the override button. Now you can manipulate all functions of the selected fixtures,
completely independent from the running sequence. At any moment you can select or
unselect additional fixtures. Once a fixture in unselected or the override function is
disabled, the fixtures continue the sequence.
FILE DUMP
It is possible a memory dump from one SM-1612 to another SM-1612. This saves you
a lot of programming work!
1. Prepare to send file dump: these actions have to be carried out on the
Scanmaster that has to send the file dump.
a. Turn the power off.
b. Press the following buttons at the same time and hold down while you turn on
the power:
JB SYSTEMS®
 fixture2 button
 fixture3 button
 scene1 button
13/89 SM-1612 SCANMASTER
OPERATION MANUAL