dosatron D30 GL 1 EC Manuel D'utilisation page 25

The D30GL unit features a 3" BSP thread male connector. Before screwing it to
your water supply system, make sure that you apply sealing tape/compound to
the threads of the DOSATRON regulator.
B. Flange connection
The D30GL is supplied with 2 x ISO - DN80 flange connections that you can
screw directly onto the DOSATRON regulator. Please make sure that you apply
sealing tape/compound to the threads of the DOSATRON regulator. g p p p p p p p p p
The DOSATRON is delivered with a suction tube (cut it to the needed
length) enabling its use with a large capacity concentrate container.
The tube must be fitted with its strainer and weights.
The instructions for fitting the tube are to be found on page 50.
The maximum suction height is 4 meters (13 vertical feet).
Fit the tube, equipped with its strainer and its weight, and immerse it in the
concentrate solution to be injected.
- Do not put the strainer on the bottom.
© © DOSATRON INTERNATIONAL / 46 DOSATRON INTERNATIONAL / 46
g
Fig. 2
Valve
ning situations).
The DOSATRON can be connected to
the main water line (Fig. 2A),
recommended.
If your flow rate is above the operating
limits of the DOSATRON, see
EXCESSIVE FLOW.
To prolong the working life of the
DOSATRON it is advisable to install
a filter (ex.: 200-120 mesh - 80-130
microns depending on your water
quality) upstream.
This is imperative if the water contains
impurities or particles, especially if the
water comes from a well.
If your DOSATRON clicks more than
you are close to the superior flow limit. If you need more flow, you must install a
DOSATRON with a superior capacity of flow (please ask advice).
© © DOSATRON INTERNATIONAL / 47 DOSATRON INTERNATIONAL / 47
Fig. 2A
Filter
Check
valve
-
respect the rules and regula-
that is ,