Publicité
Les langues disponibles
Les langues disponibles
3. Insert the battery and turn the trimmer vertical with the
blades toward the ground and run the trimmer for a few
seconds to fully disperse the lubrication.
4. Keeping your hands away from the blade, slide the
sheath
7
over the blade until it snaps into place as
shown in Figure M
Fig. M
Storage
Fertilizers and other garden chemicals contain agents which
greatly accelerate the corrosion of metals. Do not store the
unit on or adjacent to fertilizers or chemicals.
Accessories
WARNING:
those offered by CRAFTSMAN, have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Versatrack™ (Fig. N)
WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
WARNING:
personal injury, do not use a damaged Versatrack™
integral hang hook or Versatrack™ Trackwall.
A damaged Versatrack™ integral hang hook or
Versatrack™ Trackwall will not support the weight of
the tool.
WARNING:
personal injury, DO NOT suspend tool overhead or
suspend objects from the integral hang hook. ONLY
suspend tool on the Versatrack™ Trackwall using the
integral hang hook.
WARNING:
hang hook is intended to mount the tool onto a
7
Since accessories, other than
To reduce the risk of
To reduce the risk of serious
To reduce the risk of serious
The Versatrack™ integral
Versatrack™ Trackwall rail. Do not use the integral
hang hook to mount the tool to any other surface.
WARNING:
hang hook is not a belt hook.
WARNING:
Versatrack™ Trackwall rail, adequately space the tools
in order to not exceed 75 lb (35 kg) per linear foot.
WARNING:
sure that the Versatrack™ integral hang hook is
returned to its original position.
iMPORTAnT: Versatrack™ accessories mount compatible
tools securely to the Versatrack™ Trackwall system.
1. Turn tool off, remove the battery pack and
remove accessories.
CAUTION:
cutting teeth must have them covered securely if it is
to be on the Versatrack™ Trackwall.
2. Flip or pull open the integral hang hook
when locked into position.
3. Mount the integral hang hook to the
Versatrack™ Trackwall.
nOTE: Versatrack™ accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Fig. N
English
The Versatrack™ integral
When hanging objects on a
Before using the tool make
Any product with exposed
14
. It clicks
14
11
Publicité
