Hansgrohe Metropol 260 32513 1 Serie Instructions De Montage / Mode D'emploi / Garantie page 2

English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
32527XX1, 74524XX1
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• Models 32505XX1, 32510XX1, 32513XX1,
74505XX1, 74510XX1, 74513XX1 only:
This faucet does not include a drain or a pull rod.
• Models 32506XX1, 74506XX1, 2527XX1,
74524XX1 only: The drain is suitable for
most, but not all, lavatory sinks sold in the United
States and Canada. This drain is intended for
use in a sink with an overflow. If your sink does
not have an overflow, or if this drain is too small
for the hole in your sink, please refer to the
2
15 - 75 PSI (1-5 Bar)
145 PSI (10 Bar)
120°-140° F (48° -60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
0.5 GPM (1.9 L/min)
1⅜" (34 mm)
1⅝" (40 mm)
instructions included with the sink. Some
sinks include special drain installation instructions
and/or parts. Others require the use of a specialty
drain. Hansgrohe is not respnsible for the cost of a
specialty drain.
The hot and cold supply hoses included
with this faucet are for use with ⅜ stops.
If your stops are a different size, purchase
adapters at your local plumbing supply
store or home center. Adapters are not
available from Hansgrohe.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.