Siemens TE525F Série Mode D'emploi page 43

Problem
Restore the unit to its
original factory settings
("Reset").
Display shows
Refill beans! although the
bean container (1) is full,
or the grinding unit does
not grind the beans.
Display shows
Insert brewing unit
Display shows
Clean brewing unit
Display shows
Empty drip tray
despite the drip tray being
empty.
Display shows
Check water tank
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
Cause
You changed some
settings and want to
discard them.
Beans are not falling into
the grinding unit
(beans too oily).
Brewing unit (5) is missing
or was not recognised.
Brewing unit (5) is soiled.
Too much pre-ground
coffee in the brewing
unit (5).
The brewing unit's
mechanism is stiff.
Emptying is not detected
when the appliance is
switched off.
The drip tray is soiled.
Water tank wrongly
inserted.
Carbonated water in the
water tank.
Float is stuck in the water
tank.
New water filter did not
rinse according to the
instructions.
Air in the water filter.
Water filter is old.
Simple troubleshooting
Solution
Turn off the unit with the power
on/off switch O / I (9). Press and
hold the k off / i (13) and the l
(12) button and turn the appliance
on with the power on/off switch
O / I (9). Confirm by pressing the
start button start (10). The factory
settings are now activated.
Gently tap the bean container (1).
Change the type of coffee if
necessary.
When the bean container (1) is
empty, wipe it with a dry cloth.
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance.
Clean brewing unit (5).
Clean brewing unit (5).
Pour in no more than 2 level
measuring spoons of ground
coffee.
Remove and clean the brewing
unit, see "Maintenance and daily
cleaning".
When the appliance is switched
on, remove and re-insert the drip
tray.
Clean the drip tray thoroughly.
Insert water tank correctly.
Fill the water tank with fresh tap
water.
Remove the tank and clean
thoroughly.
Rinse the water filter according to
instructions and then switch on.
Dip the water filter into water
until no more air bubbles escape,
replace the filter.
Insert a new water filter.
en
39