Siemens TE525F Série Mode D'emploi page 36

en Maintenance and daily cleaning
■ Do not use abrasive cloths or cleaning
agents.
■ Always remove any limescale, residues
of coffee or milk, cleaning or descaling
solution immediately. Such residue can
cause corrosion.
■ New sponge cloths may contain salts.
Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
■ Pull the drip tray (8c) with the coffee
grounds container (8b) forward and
out. Remove the panel (8a) and the
grate (8d). Empty and clean the drip tray
and coffee grounds container.
■ Remove the float (8e) and clean with a
damp cloth.
■ Wipe out the inside of the appliance
(holder, trays) and the drawer for ground
coffee (this cannot be removed).
L
Do not put the following items in
the dishwasher: drip tray panel (8a),
brewing unit (5a).
M
The following items are dishwasher-
safe: milk frother (6) drip tray for
coffee outlet (8c), coffee grounds con-
tainer (8b), grate for coffee outlet (8d),
aroma cover (2), all parts of the milk
frother (6) and powder spoon (19).
32
Important: The drip tray and coffee
grounds container should be emptied and
cleaned every day in order to prevent
deposits.
N.B.: If the appliance is cold when switched
on with the power switch O / I (9) or if it
switches off automatically after coffee has
been dispensed, it rinses automatically. In
other words the system cleans itself.
Important: If the appliance has not been
used for a prolonged period of time (e.g.
after a vacation), clean the entire appliance
thoroughly, including the milk system and
brewing unit.
Cleaning the milk system
If the milk system was not cleaned after
milk has been dispensed, after a certain
amount of time the message Clean milk
system! will appear on the display.
Clean the milk system immediately after
use!
To pre-clean the milk system automatically:
■ Select j by turning the rotary knob (15).
■ Place a tall, empty container under the
outlet (6a).
■ Push the outlet as close as possible to
the container.
■ Place the end of the milk tube (6c) into
the container.
■ Press the start button (10).
The machine automatically releases water
into the container and vacuums it up again
via the milk tube to rinse the milk system.
The rinse procedure stops automatically
after about 1 minute.
■ Empty the container and clean the milk
tube (6c).
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).