Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
If you experience
Vibration or Off-Balance
Vibration, rocking, or
Feet may not be in contact with the
"walking"
floor and locked.
Washer may not be level.
Vibration during spinning
Load could be unbalanced.
or washer stopped
Noises – For normal operating sounds, go to www.whirlpool.com/product_help.
Clicking or metallic
Objects may be caught in washer
noises
drain system.
Gurgling or humming
Washer may be draining water.
Humming
Load sensing may be occurring.
Whirring
Basket may be slowing down.
Water Leaks
Check the following for
Washer not level.
proper installation:
Fill hoses not attached tightly.
Fill hose washers
Drain hose connection
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded as
recommended.
Washer not performing as expected
Not enough water
Load not completely covered
in washer
in water.
All manuals and user guides at all-guidesbox.com
Possible Causes
Solution
Front and rear feet must be in firm contact with floor, and washer
must be level to operate properly.
Check floor for flexing or sagging. If flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in the Installation Instructions.
Load items in loose heaps evenly around the washplate.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Avoid washing single items. Balance a single item such as a
rug or jean jacket with a few extra items. If the dial is flashing,
redistribute the load, close the lid, and touch and hold the
START/PAUSE button.
Use Bedding/Bulky and Heavy Duty cycle for oversized,
non-absorbent items such as comforters or poly-filled jackets.
Other items are not appropriate for Bedding/Bulky Heavy Duty
cycle. See "Cycle Guide."
Item or load not suitable for selected cycle. See "Cycle Guide"
and "Using Your Washer."
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump. It may be
necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming
sound with periodic gurgling or surging as final amounts of water
are removed during the spin/drain cycles.
You may hear the hum of the sensing spins after you have
started the washer. This is normal.
You may hear the whirring sound of the basket slowing down.
This is normal.
Water may splash off basket if washer is not level.
Tighten fill-hose connection.
Make sure all four fill hose flat washers are properly seated.
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Do not place tape over drain opening.
Water can back up out of a clogged sink or drainpipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets.)
An unbalanced load can cause basket to be out of alignment
and cause water to splash off tub. See "Using Your Washer"
for loading instructions.
This is normal operation for an HE low-water washer. The load
will not be completely underwater. The washer senses load
sizes and adds correct amount of water for optimal cleaning.
See "What's New under the Lid."
IMPORTANT: Do not add more water to washer. Adding water lifts
the items off the washplate, resulting in less effective cleaning.
Run clean washer cycle to optimize the water level and wash
performance.
15
Publicité
