Publicité
Les langues disponibles
Les langues disponibles
NON-USE AND VACATION CARE
Operate your washer only when you are home. If you are
moving or not using your washer for a period of time, follow
these steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer to avoid flooding
due to water pressure surge.
CLEANING YOUR DISPENSER
You may find laundry product residue leftover in your
dispenser drawer. To remove residue, follow this
recommended cleaning procedure:
1. Pull drawer out until you feel resistance.
2. Push one tab downward, then continue pulling out.
3. Wash in warm, soapy water, using a mild detergent.
4. Rinse with warm water.
5. Air dry or dry with a towel, then place back into slot.
IMPORTANT: Dispenser drawer and tray are not
dishwasher-safe.
WINTER STORAGE CARE
IMPORTANT:
To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize washer:
1. Shut off both water faucets; disconnect and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in the basket
and run the washer on the Rinse & Spin cycle for about
30 seconds to mix antifreeze and remaining water.
3. Unplug washer or disconnect power.
14
All manuals and user guides at all-guidesbox.com
TRANSPORTING YOUR WASHER
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2. If washer will be moved during freezing weather, follow
"Winter Storage Care" directions before moving.
3. Disconnect drain from drain system.
4. Unplug power cord.
5. Place inlet hoses inside washer basket.
6. Drape power cord and drain hose over the console
and secure with masking tape.
7. Place foam packing ring from original shipping materials
back inside washer. If you do not have packing ring,
place heavy blankets or towels into basket opening.
Close lid and place tape over lid and down front of
washer. Keep lid taped until washer is placed in
new location. Transport washer in the upright position.
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on both water faucets.
2. Plug in washer or reconnect power.
3. Run washer through Bedding/Bulky and Heavy Duty
cycle to clean washer and remove antifreeze, if used.
Use only HE High Efficiency detergent. Use half the
manufacturer's recommended amount for a medium-
size load.
Publicité
