Poulan Pro PP28PDT Manuel D'instructions page 28

IDLE SPEED ADJUSTMENT
WARNING:
making idle speed adjustments. The chain
will be moving during most of this procedure.
Wear your protective equipment and observe
all safety precautions. After making adjust-
ments, the chain must not move at idle speed.
The carburetor has been carefully set at the
factory. Adjustment of the idle speed may be
necessary if you notice any of the following
conditions:
S Engine will not idle when the throttle is re-
leased.
S The chain moves at idle.
Make adjustments with the unit supported so
the pruner is off the ground and the chain will
not make contact with any object. Hold the
unit by hand while running and making adjust-
ments. Keep all parts of your body away from
the chain and muffler.
To adjust idle speed:
Allow engine to idle. Adjust idle speed until en-
gine runs without chain moving (idle too fast)
or stalling (idle speed too slow).
Turn idle speed screw clockwise to increase
engine speed if engine stalls or dies.
Turn idle speed screw counterclockwise to de-
crease engine speed if chain moves at idle.
WARNING:
after each adjustment. The chain must not
move at idle speed to avoid serious injury to
the operator or others.
If you require further assistance or are unsure
about performing this procedure, contact your
authorized service
1- -800- -554- -6723.
Idle speed screw
Keep others away when
Recheck the idle speed
dealer or call
28